3D Printing - What parts do you want?

PurePain · Posted: Sat Jan 16, 2016 12:55 pm Post subject:

No mine is just a regular single extruder no scanner.

After using the factory software for a week i'm glad it didn't come with a scanner. The software is terrible sometimes it drags the nozzle over what it's just printed. Going to flash the firmware today so i can use repetier

Woggin · Posted: Sun Jan 17, 2016 8:09 pm Post subject:

ive heard good and bad.

if your over extruding just a bit every layer, it can get to the point where the nozzle is 'inside' the print, thus it hits the print.

its such a learning curve, its good, i like the challenge.
_________________

JZS147 CLUB STICKERS
http://www.jzs147.com.au/forum/viewtopic.php?t=13060

JZS147 stock snails 12.58@115, T04Z is here, still in beta!
92 r32 gtst daily

Old rides: 04 zze123r, 98 ae111r, 92 ep82gt, 92 sw20r, 00 ncp10r, 91 uzz31, 84 Ma61, 88 gz20, 90 jza70, 90 jza70 aerotop

steeaboo · Posted: Thu Aug 31, 2023 12:05 pm Post subject:

I know you still float around here Woggin, an idea for you is a dual 52mm gauge pod for where the ashtray/12v socket goes! or possibly the clips for the cupholders that are always eating sh*t on our cars? Very Happy